Example Motorway

From OCAD 12 Wiki - English
Revision as of 10:49, 31 January 2013 by FBO (talk | contribs)

Jump to: navigation, search

Motorway.PNG

The following colors are used for this symbol:

Colors Motorway.PNG

a: black above for the main line b: yellow above for the infill of the double line c: black below for the sidelines d: yellow below for the framing

It is important that the colors are in this order in the Colors Table. The sidelines are cleared automatically in this case, when drawing an intersection. Define and edit colors in the Colors dialog, which can be found in the Map menu.

To create this line symbol, enter the following parameters to a newly created line symbol:

Main Line

  • Line color: black (define and edit colors in the Colors dialog, which can be found in the Map menu). Note that this color must be above the yellow fill color in the color table. In addition, the yellow fill color must be above the color for the side lines. Therefore you need 3 colors to create this symbol: Black for the center line, yellow for the infill and black for the side lines.
  • Line width: 0.2 mm
  • Distance from start: 0.2 mm
  • Distance to the end: 0.2 mm

Motorway MainLine.PNG

Distances

  • Main length a: 1.0 mm
  • Main gap C: 0.7 mm

Motorway Distances.PNG

Double Line

  • Mode: Full lines
  • Width: 1.0 mm (This is the width of the filling, therefore also the distance between the sidelines)
  • Fill color: On checked, yellow (define and edit colors in the Colors dialog, which can be found in the Map menu). Note that this color must be below the color of the dashed line in the color table, otherwise it will cover the dashed line. In addition, it must be above the color of the sidelines, otherwise crossings are not cleared automatically.
  • Left line color: black (define and edit colors in the Colors dialog, which can be found in the Map menu). Note that this color must be below the color of the dashed line and the filling in the Color Table, otherwise crossings are not cleared automatically.
  • Left line width: 0.2 mm
  • Right line color: black (define and edit colors in the Colors dialog, which can be found in the Map menu). Note that this color must be below the color of the dashed line and the filling in the Color Table, otherwise crossings are not cleared automatically.
  • Right line width: 0.2 mm

Motorway DoubleLine.PNG


Download link: Example_Motorway.ocd


Back to the Create a New Line Symbol page.